Posts by this author.

Gas-Assisted Injection Molding: Hollow Ribs, Saved Weight, and the Voids That Give It Away
Gas replaces packing pressure, not injection pressure. What gas-assisted molding genuinely saves in mass, clamp tonnage and cycle time, and the outgassing failure that appears later in the paint line.
Alex Yu
Low-Pressure Injection Molding: The Force Budget That Decides Whether Your Insert Survives
Low-pressure injection molding protects boards because hot-melt thermoplastics flow fast, not because the pressure number is small. The cavity-pressure arithmetic, the material mistake most guides repeat, and when to pot instead.
Alex Yu
Hot Runner Injection Molding: Valve Gates, Purge Math, and True Cost of Ownership
Hot runner molding costed honestly: cycle and resin arithmetic with the assumptions shown, the energy and purge columns everyone omits, valve vs thermal gates, and when cold runner wins.
Alex Yu
PCB Overmolding: Low-Pressure Encapsulation, Materials, and Component Survival
PCB overmolding is a force budget, not a moulding job: low-pressure encapsulation vs high-pressure vs potting, component-force arithmetic, board fixturing, and the verification that actually matters.
Alex Yu
Plastic Overmolding: How the Bond Is Made, Measured, and Lost
Plastic overmolding explained by the people who cut the steel: the four adhesion mechanisms, keyed geometry rules, material pairs that actually bond, and how to prove the bond before production.
Alex Yu
High Volume Plastic Injection Molding: Prototype to Million
High volume plastic injection molding without re-qualification: tool steel life, cavity math, cycle economics, and the path from first shot to annual lots.
Alex Yu
T1 Samples in Injection Molding: The Evidence Package
T1 samples in injection molding as an evidence package: cavity traceability, process actuals, tool state, honest stats, and a one-page gate.
Alex Yu
Injection Molding Sample Approval: T1, T2, PSW
Injection molding sample approval: what a T1 package must contain, why cavity-level data matters, what a PSW declares, and when to refuse to sign.
Alex Yu
The Injection Molding Quality Agreement: AQL & CAPA
Injection molding quality agreement that ends defect arguments: per-class AQL levels, Cpk gates with raw data, CAPA clocks in hours, and scrap cost rules.
Alex Yu