
The Mold Making Process, Stage by Stage: 8 Gates, Where Weeks Get Lost, and What to Hold in Writing
Alex Yu
Black Oxide Coating: What a One-Micron Conversion Film Does and Does Not Do
Black oxide is a conversion coating, not a barrier: 0.2 to 1.5 micrometres of magnetite, negligible effect on fits, and corrosion protection that lives or dies on the oil supplement. Hot versus mid versus room temperature, what to write on the drawing,…
Alex Yu
High-Resolution 3D Printing: What 25 Microns Does Not Tell You About Your Part
Layer height, minimum feature size and dimensional tolerance are three independent limits. The span arithmetic on published per-process figures, how much detail finishing spends, and the coupon that proves it before you commit the part.
Alex Yu
Low-Pressure Injection Molding: The Force Budget That Decides Whether Your Insert Survives
Low-pressure injection molding protects boards because hot-melt thermoplastics flow fast, not because the pressure number is small. The cavity-pressure arithmetic, the material mistake most guides repeat, and when to pot instead.
Alex Yu
PCB Overmolding: Low-Pressure Encapsulation, Materials, and Component Survival
PCB overmolding is a force budget, not a moulding job: low-pressure encapsulation vs high-pressure vs potting, component-force arithmetic, board fixturing, and the verification that actually matters.
Alex Yu
Plastic Overmolding: How the Bond Is Made, Measured, and Lost
Plastic overmolding explained by the people who cut the steel: the four adhesion mechanisms, keyed geometry rules, material pairs that actually bond, and how to prove the bond before production.
Alex Yu