
Injection Molding Defect Troubleshooting: Triage Order, Interaction Effects, and the Fix-vs-Rebuild Math
Alex Yu
Polycarbonate Injection Molding: Moisture, Stress, and the Clarity Bill
Moisture hydrolyses polycarbonate at melt temperature, so a clear, glossy part can still fail a drop test. The moisture target, residual-stress testing, PC versus PMMA numbers, and where PC is the wrong material whatever the process does.
Alex Yu
ABS Injection Molding: Grade Choice, Process Window, and Where ABS Fails
Grade families with the numbers that separate them, the melt and mould window with what breaks at each edge, relative part-cost arithmetic, a defect triage table, and the four service conditions that end the ABS conversation.
Alex Yu
Black Oxide Coating: What a One-Micron Conversion Film Does and Does Not Do
Black oxide is a conversion coating, not a barrier: 0.2 to 1.5 micrometres of magnetite, negligible effect on fits, and corrosion protection that lives or dies on the oil supplement. Hot versus mid versus room temperature, what to write on the drawing,…
Alex Yu
High-Resolution 3D Printing: What 25 Microns Does Not Tell You About Your Part
Layer height, minimum feature size and dimensional tolerance are three independent limits. The span arithmetic on published per-process figures, how much detail finishing spends, and the coupon that proves it before you commit the part.
Alex Yu
3D Print Warping: Contraction, Restraint, and the Point Where Settings Stop Working
Warping is contraction fighting restraint, and the contraction comes from the polymer rather than your slicer. The movement arithmetic on a real span, which fixes only add restraint, and when machining that face is cheaper than a fourth attempt.
Alex Yu
Transparent and Translucent Parts: Clarity Is a Process Discipline, Not a Material Choice
Clear parts fail from moisture, contamination, cold tooling and trapped air. Specify haze and transmittance to ASTM D1003 instead of writing "must be clear" on the drawing.
Alex Yu
Hot Runner Injection Molding: Valve Gates, Purge Math, and True Cost of Ownership
Hot runner molding costed honestly: cycle and resin arithmetic with the assumptions shown, the energy and purge columns everyone omits, valve vs thermal gates, and when cold runner wins.
Alex Yu
PCB Overmolding: Low-Pressure Encapsulation, Materials, and Component Survival
PCB overmolding is a force budget, not a moulding job: low-pressure encapsulation vs high-pressure vs potting, component-force arithmetic, board fixturing, and the verification that actually matters.
Alex Yu