
Polycarbonate Injection Molding: Moisture, Stress, and the Clarity Bill
Moisture hydrolyses polycarbonate at melt temperature, so a clear, glossy part can still fail a drop test. The moisture target, residual-stress testing, PC versus PMMA numbers, and where PC is the wrong material whatever the process does.
Alex Yu
ABS Injection Molding: Grade Choice, Process Window, and Where ABS Fails
Grade families with the numbers that separate them, the melt and mould window with what breaks at each edge, relative part-cost arithmetic, a defect triage table, and the four service conditions that end the ABS conversation.
Alex Yu
Transparent and Translucent Parts: Clarity Is a Process Discipline, Not a Material Choice
Clear parts fail from moisture, contamination, cold tooling and trapped air. Specify haze and transmittance to ASTM D1003 instead of writing "must be clear" on the drawing.
Alex Yu
Gas-Assisted Injection Molding: Hollow Ribs, Saved Weight, and the Voids That Give It Away
Gas replaces packing pressure, not injection pressure. What gas-assisted molding genuinely saves in mass, clamp tonnage and cycle time, and the outgassing failure that appears later in the paint line.
Alex Yu
Low-Pressure Injection Molding: The Force Budget That Decides Whether Your Insert Survives
Low-pressure injection molding protects boards because hot-melt thermoplastics flow fast, not because the pressure number is small. The cavity-pressure arithmetic, the material mistake most guides repeat, and when to pot instead.
Alex Yu
Hot Runner Injection Molding: Valve Gates, Purge Math, and True Cost of Ownership
Hot runner molding costed honestly: cycle and resin arithmetic with the assumptions shown, the energy and purge columns everyone omits, valve vs thermal gates, and when cold runner wins.
Alex Yu
PCB Overmolding: Low-Pressure Encapsulation, Materials, and Component Survival
PCB overmolding is a force budget, not a moulding job: low-pressure encapsulation vs high-pressure vs potting, component-force arithmetic, board fixturing, and the verification that actually matters.
Alex Yu
Plastic Overmolding: How the Bond Is Made, Measured, and Lost
Plastic overmolding explained by the people who cut the steel: the four adhesion mechanisms, keyed geometry rules, material pairs that actually bond, and how to prove the bond before production.
Alex Yu
What Are The Best Ways to Prevent And Fix Sink Marks In Injection Molding?
What Are The Best Ways to Prevent And Fix Sink Marks In Injection Molding? Are your plastic parts showing ugly dents on the surface? This ruins your product look and hurts your brand. We can fix this problem for good. The best…
Alex Yu